Heavy duty 50Hz chargers for Heavy Industrial Environments.
Narrow aisle trucks
Advanced Controlled Current Charging Profile. This is gentle on the battery and extends battery life.
Auto-Cut-Off when battery is 100% Charged.
Battery Manufacturer recommended Constant Current EQUALISE Facility to increase battery life.
LCD display to display charging voltage, charging current, charge time and Ampere Hours put back. Easy for troubleshooting and preventive maintenance.
No Overcharging/Undercharging due to dv/dt Charge Status Evaluation electronic circuits.
Electronic protection against reverse battery, over current & short circuit.
Front panel LEDs for displaying charging and fault status.
Voltage range 380VAC – 450VAC.
For Recharging And Equalising Of Flooded Lead Acid Batteries
The modes available are :
This is used to Recharge a battery has been used by the equipment.
Connect the charger to AC and the Battery. The charger evaluates the condition of the battery, starts charging at the programmed current and stops charging when battery is 100% charged.
Battery manufacturers insist that batteries should be equalised to extend battery life. Leading battery manufacturers recommend true constant current equalizing. This is to extend battery life.
Equalising charge is required for batteries after they are fully charged to make sure
that all cells are balanced. This means that all cell voltages and battery specific gravities are approximately equal. This ensures that all cells of the battery are discharged equally during the work-shift phase. This prevents sulphation in some cells. This extends battery life.
The Sirius Charger in 'EQUALISE mode' allows charging of batteries that are deeply discharged.